FOXWELL BT100 Pro 12V Car Battery Tester AGM GEL Charging Analyzer 100-1100CCA

Description

IT WILL DEFINITELY MAKE YOU IMPRESSED! The theme of this 12V car battery load tester named FOXWELL BT100 pro is
Minimalism
. All the creative inspirations are out of the convenience for our customers, such as
quick start
,
portable size
,
safe&easy operation, accurate test result
and so on. Removes redundant and useless programs, which makes the battery analyzer
for car
run faster.
You're allowed to use it directly out of the package and don’t have to update or install any software on the car alternator tester.
Replace Your Bad Battery In Time:
Generally, a battery dies and you replace or charge it, but it is hard to tell when a deep cycle battery is going to die. This 12 volt digital battery tester gives you the information about the life of your batteries, instead of guessing, or vaguely remembering when it was last replaced or charged. It also allows you to test a battery to see if the problem is the battery or your charging system before spending money for replacing parts unnecessarily.
With this little household battery tester, you can
check the battery by yourself just in seconds
, and avoid the hassle of driving to repair shop to find out if your battery is good or not. The most important thing is, it makes you
know the problem and replace the battery
in advance
before it leaves your car dead on road.
Any questions or problems, keep in touch via online Amazon messages, we'll reply to you within 5 hours on average.
Please note that this battery tester CANNOT test 6v/24v batteries.
If you are testing inside a vehicle, make sure all accessory loads are cut off, the key is not in the ON position and the doors are closed.
Do not connect the tester to a voltage source greater than 18V DC, otherwise you may damage the tester.
If you want to adjust CCA rapidly, just hold on up/down button.
Please note that this battery tester for car can't do load test and deep cycle.
Battery Tester Results:
GOOD BATTERY: The battery is in good condition.
GOOD-RECHARGE: The battery is in good condition but low current. Fully charge the battery and return it to service.
CHARGE & RETEST: Fully charge the battery and retest. Failure to fully charge the battery before testing may result in inaccurate results. If you still get CHARGE & RETEST message after you fully charge the battery, replace it.
REPLACE BATTERY: The battery is almost dead or the connection between the battery and battery cable is poor. Replace the battery and retest; or disconnect the battery cables and retest the battery using the out-of-vehicle test before replacing it.
BAD CELL-REPLACE: The battery may be damaged such as broken cell or short circuit. Replace the battery and retest.
Four-Key Operation:
The latest four-key design makes this battery analyzer simple and convenient to use.
Streamline Design:
This battery tester features user-friendly ergonomics and comfortable operation.
Handheld Size:
Compact for storage, fit right in your toolbox, and handy to have around.
In order to
make the test result more accurate
, please notice the followings before testing:
1. Turn off all electronic equipments.
2. When you completed charging, please wait for half an hour to test.
3. New battery need to be full-charged, and also need to wait for half an hour to test.
4. When connect the claps to the battery, please make sure the claps are perpendicular to the terminal post.