-40%
Brake Levers PAIR for Bicycle 7/8 Dia Handlebar. USED but works good.
Brake Levers PAIR for Bicycle 7/8 Dia Handlebar. USED but works good.

Brake Levers PAIR for Bicycle 7/8 Dia Handlebar. USED but works good.

$ 5.25

Availability: 22 in stock
  • Type: Brake levers
  • All returns accepted: Returns Accepted
  • Brand: PSE
  • Condition: These are a good used levers. They have rust on the mettal parts as you can see in the picture.
  • Part Type: Brake Levers
  • Return shipping will be paid by: Buyer
  • Brake Type: Caliper Brake - Side Pull
  • Refund will be given as: Money Back
  • Color: Black
  • Item must be returned within: 30 Days

    Description

    >>
    DESCRIPTION:
    This is a pair of good used Brake Lever.   They look OK except the metal parts have a lot of rust on them which you can see in the picture, but they work good.  I don't know what they are made of.  They look like they are made of some kind of plastic or nylon material.
    These levers are for traditional cantilever brakes (like the brakes that are on many higher priced older ATB and Mountain Bikes), and they are for caliper brakes (the side-pull brakes that are on many lower priced ATB, Mountain Bikes, and other bicycles).
    Any lever that is made for traditional cantilever brakes and side-pull caliper brakes  is not recommended for V-type brakes
    - also called linear pull or direct pull brakes (the kind that are on most new ATB and Mountain Bikes) because V-type brakes have a different amount of pull needed.
    The left lever gets to a place where it is loose if you pull it that far, but it seems to have been made that way and it works OK.
    One of the pictures above shows my measurements, which could be somewhat different from the actual measurements, but I tried to measure them correctly.
    They have an adjusting barrel like other brake levers.  Brake cable housing with a diameter of the usual 5 mm will go in the adjusting barrel either with or without a ferrule on the end of the cable housing.
    The cables are NOT included.
    It fits handlebars that are 7/8" diameter, which is the diameter lf most handlebars.
    It will NOT fit handlebars that are more than 7/8" diameter.
    You will need a 5 mm Hex Wrench to tighten the clamp.
    A hex wrenhk is NOT included.
    >>
    Shipping:
    We
    will send this item by
    First Class Mail with tracking
    within 2 business days after receiving cleared payment by Paypal.  Payments are usually cleared immediately upon payment except for e-checks. We ship only to addresses in the USA.
    Usually, the Postal Service delivers within 2 to 6 days after shipment, but sometimes it takes them 30 days or longer to deliver First Class Mail.
    Thanks.
    texarksales - Bicycle Shop